北京塞车pk10计划视频

Consulting Hotline: 15169463938

Qingzhou Qiannuo Machinery Co., Ltd.

Contact: Manager Zhang

Fax: 0536-3579821

Phone: 151-6946-3938

Postcode: 262515

Address: Qingzhou Economic Development Zone, Shandong


Electrical safety issues when processing spiral blades

When we manufacture spiral blades, many welding, extrusion, and winding processes are used for molding. These processes need to be powered. For this product, we must pay more attention to the power. We will introduce the spiral blade processing in the following. Electrical safety matters:
1. During installation, be sure to operate according to specific regulations to avoid affecting subsequent use.
2. Specialty is very important. To this end, inspectors and maintenance personnel need to undergo special training in processing spiral blades before they can take up their posts.
3. The switch needs to be insulated and the device must be stable. After work, be sure to check whether the power switch is in the off state.
4. Before opening the electrical box, write on the device that no outsiders can enter, ensure that the power supply and the machine are in an isolated state, and turn off the main power supply of the device.
5. When processing the blade, pay special attention to its power supply must be grounded, and the connected circuit, the operator can not directly touch with his hands.
6. In the process of use, adequate safety measures must be taken: ensure that the power cord is grounded and operated by specially trained personnel. At the same time, in order to ensure the normal operation of the equipment, the voltage must be stable.
In the manufacturing process of spiral blades, we hang safety on our lips. We must pay more attention to safety when using them. We have always emphasized on power. Staff need to perform pre-job training, and they cannot be touched by hand directly. To avoid danger.
Editor: xiaoy