北京塞车pk10计划视频

Consulting Hotline: 15169463938

Qingzhou Qiannuo Machinery Co., Ltd.

Contact: Manager Zhang

Fax: 0536-3579821

Phone: 151-6946-3938

Postcode: 262515

Address: Qingzhou Economic Development Zone, Shandong


Reasons for auger blade spreading

An important conveying accessory of the auger blade in the auger conveyor, which is what we often call a transmission device, but in the process of use, it is prone to spreading. This phenomenon brings a lot of users Waste of resources, why is this? Let's analyze the reasons for spreading the leaves:
1. Spread material at the reprint point
Spreading material at the transfer point is mainly in the falling hopper, material guide groove, etc. If the conveyor is severely overloaded, the material rubber skirt of the material guide groove will be damaged. Longer, it will be able to punch the material out of the guide.
Second, the concave blade is suspended
When the curvature radius of the concave section is small, suspension will occur. At this time, the auger blade has left the grooved roller group, and the groove angle becomes smaller and smaller, and some materials may be scattered.
3. Spread when running off course
When the product is running, there will be a phenomenon of high and low on both edges, and the material will be scattered from the low side.
Through the above analysis, we can learn that there are three reasons for the spreading of auger blades, so our staff should keep them in mind to prevent this problem from occurring in the future use process, which can be resolved in time and reduce resources. waste.
Editor: mxy